30
POWER UP THE DISPLAY
1. Plug in the power adapter to power up the console.
2. Once the console is power up, all the segments of the LCD will be shown.
3. The console will automatically enter AP mode and sensor synchronization mode automatically.
MANUAL SYNCHRONISATION OF INDOOR AND OUTDOOR UNIT
Press the [ Sensor / Wi-Fi ] key once for the console to enter sensor Synchronization mode (channel number blinking), and
the console will re-register all the sensors that have already been paired to it before.
Whenever you changed the batteries of the wireless sensor, re-synchronization must be done manually.
1. Change all the batteries to new ones in the sensor.
2. Press [ Sensor / Wi-Fi ] key on the console to enter sensor Synchronization mode.
3. Console will re-register the sensor after its batteries are changed (about 1 minute).
REMOVE SENSOR CONNECTION
User may manually delete any sensor from the console.
1. Press the [ CH / SET ] key until the console shows the display of the selected sensor.
2. Press and hold [ REFRESH ] key for 10 seconds, until its readings are reset “ -- , -°C -- % “ is shown.
WIRELESS SENSOR SIGNAL STRENGHT
1. The console display shows the signal strength of the wireless sensor(s), as per table below:
Signal strength of outdoor
7-in-1 sensor
Signal strength of outdoor
7-in-1 sensor
No signal
Weak signal
Good signal
2. If the signal has discontinued and does not recover within 15 minutes, the signal icon will disappear. The temperature
and humidity will display “Er” for the corresponding channel.
3. If the signal does not recover within 48 hours, the “Er” display will become permanent. You need to replace the batteries
and then press [ Sensor / Wi-Fi] key to pair up the sensor again.
FACTORY HARD RESET
Indoor display unit
To reset the console and start again, press the [ RESET ] key once or remove the backup battery and then unplug the
adapter. To resume factory settings and remove all data, press and hold the [ RESET ] key for 6 seconds.
Outdoor display unit
To reset the outdoor unit, press the [ RESET ] key once or remove the backup battery. To resume factory settings and
remove all data, press and hold the [ RESET ] key for 6 seconds.
