6
Indoor unit:
Slide down the battery cover at the rear of the unit and insert 3 AA 1.5V batteries according to the markings
inside the battery compartment. Slide the battery cover back onto the indoor unit. (Batteries are not included)
The indoor unit will now start a 1 minute scan to search for the outdoor unit. Therefore, you’ll need to
insert the batteries into the outdoor unit within that minute.
Outdoor unit:
Open the battery compartment by loosening the battery cover using a small
crosshead screwdriver. Install 3 AA 1.5V batteries according to the picture
below, paying attention to the correct polarity (+ and -). Replace the cover and
fasten the screw (batteries are not included).
3.2 Pairing the indoor unit/outdoor unit:
Automatically:
As soon as you insert the batteries into the indoor unit, the indoor unit will start a 1 minute scan to
search for the signal of the outdoor unit. Therefore, if you insert the batteries into the outdoor unit within
that minute and the units will ‘find’ each other, they will be automatically paired and the display of the
indoor unit will show the temperature transmitted by the outdoor unit.
Manually:
If the units cannot be paired automatically, or after replacing the batteries, you can pair the outdoor unit
(again) with the indoor unit as follows:
1. press and hold the
SCAN
button on the indoor unit for 2 seconds until the antenna symbol starts
flashing in the display
2. Press briefly press the
RESET
button on the outdoor unit
3. the units will have found each other (again) after several seconds
3.3 Positioning: reset
Indoor unit:
You may suspend the indoor unit from a simple screw in a wall or use it as a desk model
with the supplied support. In any case, never place the indoor unit in direct sunlight or next
to heat radiating lights or stoves.
Outdoor unit:
You may place the outdoor unit on a flat surface (such as a fence or railing)
or on top of a pole (not included). In any case, make sure the unit is placed
at least 1.5 meters above the ground and ensure the unit is standing freely
in the rain and wind.
Outdoor unit positioning tips:
To ensure that the rain meter is functioning as accurate
as possible, the outdoor unit must be standing exactly
horizontal. You can verify this by using the built-in spirit
level at the top of the outdoor unit.
To be able to check from which direction to wind is
coming, the outdoor unit should be aimed to the North. To do this, use the
N
marking on top of the outdoor unit. Use an accurate compass (not included)
to properly orient the unit.
Make sure that the distance between the outdoor unit and indoor unit is no
greater than 50 to 100 meters.
reset
>1,5m
N
-
-
+