13
7.2 To set Hi-Lo limits:
1. repeatedly press the button until the desired display is flashing with the indication ‘HI AL’ or ‘LO
AL’ next to it (if applicable)
2. use / to set the limit
3. briefly press the button again to save the value
4. press the button again to select the next display or wait several seconds for the setup mode to
end automatically
7.3 Hi-Lo Alarm function setup:
1. repeatedly press the button until the desired display is flashing with the indication ‘HI AL’ or ‘LO
AL’ next to it (if applicable)
2. briefly press the button to enable or disable the selected alarm
7.4 Operation:
As soon as the set limit is exceeded, an alert tone will sound for up to 2 minutes while the concerned
display flashes and the alert indicator underneath the display flashes every 7 seconds. Briefly press the
button to stop the alert ton. The flashing stops automatically as soon as the concerned measurement
returns to within the set limits (or when you adjust the limit or disable the alarm function for the
concerned measurement).
8. RELATIVE AIR PRESSURE
8.1 Introduction:
When you’re living considerable higher than the mean sea level, you’ll be experiencing a lower air
pressure. To ensure that the weather forecast is still accurate, you’ll need to correct the air pressure
according to your where you live.
8.2 Relative air pressure setup:
1. refer to the internet or your local authorities for information about your local air pressure
2. press and hold the button for 2 seconds until ‘absolute’ or ‘relative’ starts flashing
3. use / to select ‘relative’
4. briefly press and the air pressure display starts flashing
5. use / to correct the display by setting it to the value you’ve obtained from your local authorities or
the internet
6. briefly press to save the air pressure
9. PROBLEM SOLVING
Problems
Solutions
No or strange measurements from the rain sensor
• Check the drain in the rain meter; it must be opened.
• Check whether the rain meter sits horizontal.
No or strange measurements from the thermometer and humidity
meter.
• Check whether the air grooves are open.
• Check the sensor casing.
No or strange measurements of wind speed and wind direction.
• Check the weather vane.
• Check the wind cups of the wind speed meter.
and
---
(reception signal lost for 1 minute)
• Move the indoor unit closer to the outdoor unit.
• Make sure that the indoor unit is not placed near other
electronic equipment that might cause interference due to
wireless transmissions (TV, PC, microwave)
• When the problem remains, please reset both the indoor and
outdoor unit.
and
Er
(reception signal lost for 1 hour)