ALE TC Series, Руководство оператора

Страница: 11 / 18

Design • Print • Trace
07/07/2011
2.2 Inking up for the first time "from dry"
It is recommended that the printer is removed from the production line
during this procedure as there is a risk of ink spillage. Fix the printer to a
suitable support.
●
Support the TC print-head to a floor-stand, in printing position.
●
With the controller switched off, connect it to the print-head using the data cable
from the TC series print-head.
Note : the TC print-head can be connected either to a J-Series controller (D25 cable format)
or a Master Pad controller (IEEE1394 cable format). The following procedure describes how
to operate the TC print-head with a J-Series controller. For instructions on how to operate a
TC print-head with a Master Pad controller, please ask your distributor for a Master Pad
user manual.
●
Remove the air pin from the ink tray (Fig. 12). This pin prevents leaks from the
reservoir during shipment. Also remove the cap from the reservoir.
●
Place a collecting bucket in front of the print-head (Fig. 13).
●
For the TC72 OIL version, fit an
ALE
BOBET7X 250mL ink bottle in the reservoir
●
For the TC54 OIL version or TC18 OIL version, fit an
ALE
BOB 250mL ink bottle in the
reservoir.
SAFETY WARNING! The inks and solvent cleaners are chemical
products. In the interests of safety, read the Material Safety Data
Sheets carefully before handling the fluids. Always wear protective
gloves and eye protection when in contact with any inks or solvents.
TC series print-heads Operator Manual 7
Fig. 12: Remove air pin and
cap
Fig. 13: Place a collecting bucket in front of the print-head