1100W Garden Pump
AFTER SALES SUPPORT
e-mail: [email protected]
1800 909 909
MODEL: №.
XKJ-1109PE • 1/2018 • 44268
(toll free)
AFTER SALES SUPPORT
(toll free)
1100W Garden Pump
e-mail: [email protected]
1800 909 909
MODEL: №.
XKJ-1109PE • 1/2018 • 44268
32
33
Maintenance & Cleaning
WARNING: Ensure the Garden Pump is disconnected from the mains
power supply before undertaking any maintenance.
To ensure a long service life, we recommend regular checks and care
of your Pump.
• After long stoppages, make sure the rotor turns correctly by briefly
switching the pump on and off.
• If the pump is not going to be used for a long time or has to be removed
for the winter months, rinse it out with water, empty it completely and
allow it to dry. The external housing of the garden pump can be cleaned
using mild soapy water and a cloth. Do not use detergents.
• If there is a risk of frost, the Pump needs to be emptied completely
and dry.
• If the Pump becomes blocked, remove the outlet fitting and remove
the blockage if possible. If the blockage is on the input side, the screws
retaining the base can be removed to remove the base and cover. Clear
the blockage from the impellor. Then replace the cover and base and the
assembly screws.
NOTE: DO NOT separate the lower and upper housing of the Pump.
• Before using the Garden Pump, always inspect it visually. Do not use the
Pump if it is cracked and/or damaged. If the Garden Pump is damaged,
contact customer service.
• Make sure that electrical connections are protected from inundations.
• Protect the plug and the power cable from heat, oil or sharp edges and
away from water and moisture.
• If damaged, the power cable must be replaced by a qualified electrician.
• If the supply cord is damaged, it must be replaced with a special cord or
assembly, available from the manufacturer or service agent.
Storage:
Ensure you store your Garden Pump and accessories out of childrens reach
in a dark and dry place at above freezing temperature. The ideal storage
temperature is between 5° and 30° C
Cleaning the Coarse Filter
It is recommended to clean the coarse filter (2) approximately every 3 months
or where the water being pumped is subject to any types of dirt or debris,
clean more frequently i.e weekly or daily.
When the coarse filter is becoming clogged, the output of the pump will be
reduced indicating the pump filter needs cleaning. DO NOT run the pump
without the coarse filter (2) fitted.
1. Remove the water filler cap (1), using the large plastic spanner (8)
supplied (Fig U).
2. Remove the coarse filter (2) and the non-return valve (3) by lifting the filter
out. The non-return valve (3) is clipped onto the coarse filter (2).
The assembly should remove as shown in the Fig W.
3. If the coarse filter (2) and non-return valve (3) does not lift out of the pump,
remove the water intake screw (7) and gently push the coarse filter (2)
upward using the end of the supplied spanner (8) (Fig Y).
4. Ensure there are no blockages in the filter.
Once any blockages are cleared return the filter assembly back into
the unit.
NOTE: A blocked coarse filter (2) will reduce the life and performance of
your pump.
