Alcorn Mcbride RideTraXX, Руководство пользователя

Страница: 49 / 55

March 20, 2013
• Alcorn McBride RideTraXX User’s Manual • Rev 1.3 • Page 43
Send String
Description: This command sends an ASCII string from RideTraXX to the specified destination.
Command Bytes:
"<s>"<d><o>SS
Parameters: <s> is the string to be sent
<d> is the destination, one of:
S – Serial
U – UDP(over Ethernet)
B – USB Serial
<o> is only required for UDP, and is the destination info in the form of:
<XXX.XXX.XXX.XXX>:<PPPPP>:<SSSSS> where,
<XXX.XXX.XXX.XXX> is destination IP
< PPPPP> is destination port
< SSSSS> is source port
Comments: The <o> field is not necessary if using Serial or USB Serial destination. You must
escape all special characters in the string to be sent(such as quotation marks). For
example, "State=\"Playing\"\r" would send: State="Playing"\r
Message Response:
R
Examples:
Send „Done‟ out the serial port:
"Done"SSS
Send „Done Playing‟ to 192.168.0.254 port 2639 from port 2640:
"Done Playing"U192.168.0.254:2639:2640SS
Send „State="Playing"\r‟ to 192.168.0.254 port 2639 from port 2640:
"State=\"Playing\"\r"U192.168.0.254:2639:2640SS
Enable/Disable Crossfade Mode
Description: This command enabled or disables Crossfade Mode
Command Bytes:
E<s>XF
Parameters: <s> is either 1 (to enable) or 0 (to disable)
Comments: Crossfade Mode is saved and applied on bootup. This command only needs to be
issued once, and the setting will remain after a power cycle.
Message Response:
R
Examples:
Enable Crossfade Mode E1XF
Disable Crossfade Mode E0XF