Alcatel SPEED TOUCH PRO, Руководство пользователя

Страница: 104 / 238

Introduction
Configuration of the
STPro 'Phonebook'
page
Configuration of the
STPro 'CIP' page
10 Configuration and Use - CIP & IP Routing
104 / 238
3EC 17059 ABAA TCZZA Ed. 01
10.2.5 Configuring the STPro for CIP
After retrieving the LIS parameters, you must configure the STPro ,
according to these parameters.
This section describes in short the global procedure for
configuring your STPro 'Phonebook' and 'CIP' pages.
By default the STPro is configured for a CIP VC as used in the
example of section 10.2.7. If this VC is appropriate to your,
and/or the SP's needs, nothing has to be configured in the STPro
phonebook.
If this VC does not match the requirements, three other CIP
phonebook entries are available to add.
However, in the case none of the entries match, you must add a
CIP phonebook entry yourself.
Adding phonebook entries is described in section 11.3.
The default CIP phonebook entry mentioned above is by default
configured for a LIS according to the example of section 10.2.7. If
this LIS configuration meets your requirements, nothing needs to
be configured, and your STPro is ready for use.
However, if additional configuration is needed, you can configure
CIP members yourself.
The assignment of your CIP PVC to the CIP member can be done
implicit, or explicit, according the RFC1577/RFC2225 compliancy
of the remote access router.
Configuration of the
STPro 'CIP' page is fully described in section
10.4.