Troubleshooting
Under certain circumstances it cannot be excluded totally that current supply interruptions or interferences
may perhaps have influence on the correct functions of the set. In case of a malfunction you may re-establish
the connection by this simple test procedure in exactly the following sequence:
•
Switch off the audio-gateway by unplugging the DC power cable from audio-gateway
•
Switch off Bluetooth
TM
headset, too
•
Insert power cable again into audio-gateway
•
Switch on Bluetooth
TM
headset again
After a short moment both units should be paired again together.
If the above described method does not help, a „
general reset
“ back to the factory default settings may help.
This general reset is also necessary in all cases, where the headset has been used in connection with other
Bluetooth
TM
devices and shall now be re-connected to your individual audio-gateway. The general reset
procedure includes pairing and resetting
both
partner units (headset
and
audio-gateway), otherwise they
cannot establish a secure transmission system.
Starting general reset
Please follow the instructions in exactly the described sequence!
•
(1) Switch your headset
OFF
with power switch (slide switch).
•
(2) Switch headset
ON
again
•
(3) Press all
3 keys at headset simultaneously at the same time
and keep them pressed for
about
3 seconds.
Hold headset during that procesure close to your ears. You will hear s short
melody marking a successful reset. If you do not hear the melody within 1-2 seconds, the reset
was not successful and you should repeat steps (1) to (3).
•
Release all buttons.
•
Switch the headset 1 x
OFF
and
ON
again at the slide switch (power off-on).
•
Place the headset close to the audio gateway.
•
Press and hold the
TEST/PAIRING
button on top side of the
audio-gateway
and keep button
pressed for about 6 seconds (during this time the test LED will flash)
•
Release button
•
Disconnect the 5 V DC power supply plug from the audio-gateway.
•
Wait for about 1 second and insert the DC plug again into audio-gateway.
•
Place the headset into the charging cradle, wait and observe the test-LED. The LED will flash for
some seconds until the pairing process will be finished.
•
After pairing process is completed, you will hear a melody from the plugged-in headset. Now you
may take out the headset and use it.
