PROGRAMMING BEZEL LED COLOURS AND BRIGHTNESS
Lay the topper face downside. Remove the 6 screws placed along the rear perimetre as
well as the 2 screws located in the stem rear face. Rotate the topper face up, lift up the
front bezel and lay it aside.
Pull apart the two plexy layers, and the artwork. The board controls are now accessible.
Adjustment of bezel led brightness (3 levels)
-
switch power on; then, by
pressing several times the button located at the edge of the board, set the desired
brightness level:
1st touch:
maximum brightness
2nd touch:
middle intensity brightness
3rd touch:
lowest brightness
The latest chosen value remains set until next activation of the edge button.
Programming the bezel led colour(s) (only in RGB models):
switch power off;
then, while holding the edge button pressed, switch power on.
Release the button: from now on, by pressing several times the button located at the
edge of the board, set the desired colour:
1st touch:
all leds red light
2nd touch:
all leds green light
3rd touch:
all leds blue light
4th touch:
all leds white light
5th touch:
RGB (multicolour) operation
If 5” elapse after touching the button, the latest chosen colour gets set, and the board
returns to stand-by condition. If necessary, start again the programmino mode (as
above explained), and repeat the setting operation.
Once set the desired colour, let 5” elapse.
MOUNTING THE TOPPER
1.
Fasten the standard support (B) on the machine dome. Add the adapter (C) if the
radius of the dome is 222 mm, or else add the adapter (D) if the Topper is to be
mounted onto a shelf. See dimensional drawings, pag. 3 .
2.
Slip the Shuttle harness into the
dome.
Take care that the harness remains
within its seat!
3. Locate the Topper in position.
Pay attention: the support rear hooks
must remain within the Topper base.
ISTRUZIONI
INSTALLAZIONE
VANGUARD
ENG
, 3 di 6
