MOUNTING/REPLACING THE ARTWORK
Lay the topper face down. Remove the 6 screws placed along the rear perimetre as well
as the 2 screws located in the stem rear face. Rotate the topper face up, lift up the
front bezel and lay it aside.
Pull apart the two plexy layers, put back the lower one on the support ribs, fit the
artwork and cover it by the upper plexy layer.
Fit the front bezel, hold the whole Topper and again lay it face down. Pay attention not
to stretch the power harness. Tighten the 8 screws in.
SIZE
