Alberici Hammer Two, Руководство оператора

Страница: 16 / 22

16
8.2 BillyOne
During operation, the amount of consecutive red flashes produced by the entry slot indicates the
possible malfunctions (see chart below):
nr. of red
flashes
Message description
1 Validator has been opened
2 Jammed banknote
3 Attempted fraud detected
5 Adjust optic sensor
9 Low voltage
11 Check operation of the e motor of the validator
14 ROM error
8.3 Fraud-fishing
9. Maintenance of the note validator
9.1
BillyOne Validator
BEWARE! Switch off before opening the note acceptor.
9.1.1 Cleaning the note validator:
The acceptance capacity may decrease due to dust accumulation (dust is mostly produced by the
passage of the banknotes), or residual sprays, which can accumulate on the sensors and rollers.
It is therefore recommended that you clean these parts at least monthly, as indicated below.
Please clean such parts at least once a month, as explained here below.
1. Turn the power off, and pull off the cable
connected to the 10-pin socket interface.
Press the yellow button C (see page 6), located
under the reader, to release the main body from the
Bezel; then slide it backwards and remove it.
Dip-Switch SW2 ON
After fraud attempts, the validator returns the banknote. No signal given.
(**) Dip-Switch SW2 OFF
Attempt
Validator reaction
Do as described below
1°
Remains in service
-
2°
Remains in service
-
3°
> error (3 red flashes)
Reset (switch off then on)
… n° …
> error (3 red flashes)
Reset (switch off then on)
In validators with SW v. 1: after 5th attempt (3 yellow flashes) it is necessary to wait for
automatic restore of service. Take care not to switch the device off.
!
C