Alber UXTM, Руководство по установке

Страница: 14 / 46

Safety Information
4200-097 1-2 Revision 1.06
1.4 Product Safety Practices
The following describe safety practices particular to the installation or operation of the product.
Equipment Service
Proper installation and testing are essential to the correct functioning of the system. If you have
questions, contact Albér and request monitor assistance. Except as explained in this manual, do not
attempt to service Albér equipment.
Any adjustment, maintenance or repair of this product must be performed by qualified personnel.
Contact an Albér customer service engineer and request assistance. Only qualified and trained
personnel may perform the operations described in this manual. All safety information must be read,
understood, and strictly adhered to before installing, powering up or using the equipment or software
(the "system".)
Equipment Grounding
To minimize shock hazard, the system chassis must be connected to an electrical protective earth
ground when required. When AC mains are used for the power source, the system must be connected
to the AC power mains through a grounded power cable, with the ground wire firmly connected to an
electrical safety ground at the power outlet.
Fuses
For continued protection, fuses with the required rated current, voltage, and type, such as normal, slow
blow, fast blow or time delay, must be used.
Equipment Access
Operating personnel must not remove equipment covers, shields or panels. Component repair,
replacement, and internal adjustments must be made only by qualified service personnel.
Operating Damaged Equipment
Do not operate damaged equipment. Equipment that appears damaged or defective must be made
inoperative and secured against unintended operation until repaired by qualified service personnel.
Whenever it is possible that the safety protection features built into this product have been impaired,
either through physical damage, excessive moisture or any other reason, remove power and do not use
the product until safe operation can be verified by qualified service personnel. If necessary, contact
Albér to ensure the safety features are maintained.
Servicing and Adjusting
Do not service or adjust alone. While in the battery circuit, do not attempt internal service or
adjustment of this equipment unless another person, capable of calling for or rendering first aid and
resuscitation, is present.
Substituting Parts or Modifying Equipment
Do not substitute parts or modify equipment. Due to the possibility of introducing additional hazards, do
not substitute parts or perform any unauthorized modification to the product. If necessary, contact
Albér to ensure the safety features are maintained.