Mainboard PX915-DV
32
Suspend Mode
This option allows you to select the suspend time under the ACPI operating system.
Options: Disabled(default),1Min,2Min,4Min,8Min,12Min,20Min,30Min,40Min,1Hour
HDD Power Down
When enabled, the hard disk drive will power down after a certain configurable period of system
inactivity. All other devices remain active.
Options: Disabled (default),1 Min,2 Min,3 Min,4 Min,5 Min,6 Min,7 Min,8 Min,9 Min,10 Min,11 Min,12
Min,13 Min,14 Min,15Min
Soft-Off by PWRBTN
In situations where the system enters a “hung” state, you can configure the BIOS so that you are
required to pre the power button for more than 4 seconds before the system enters the Soft-Off state.
Options: Delay 4 Sec, Instant-Off (default).
Wake Up Control
If you highlight the “Wake Up Control” label and then press the enter key, it will display a submenu
with the following options:
P
R
U
R
D
T
**
CI PME Wake Up
This option will also cause the system to wake up with any onboard LAN activity.
Options: Disabled (default),Enabled
ing Wake Up
This option allows you to awaken the system upon receiving an incoming call to modem device. Options:
Disabled (default),Enabled.
SB KB Wake-up From S3
This option allows you to awaken the system from suspend mode using a USB keyboard.
Options: Enabled,Disabled (default)
* This option is configurable only when the ACPI Suspend Type is set to S3.
TC Wake Up
When “Enabled”, you can set the date and time at which the RTC (real-time clock) alarm awakens the
system from Suspend mode. Options: Enabled,Disabled (default).
ate (of Month) Alarm
You can choose which date of the month the system will boot up. This option is configurable only when
“RTC Wake Up” is set to “Enabled”.
ime (hh: mm: ss) Alarm
You can choose the hour, minute and second the system will boot up. This option is configurable only
when “RTC Wake Up” is set to “Enabled”.
Reload Global Timer Events**
When a system goes into suspend mode, certain devices must be inactive for a period of time.
Conversely, if any of those devices have any activity, the system will awaken. You can select the
devices that will participate in suspend/power-on activity by configuring these options. Devices
