PM800 Series
Wake Up Control
If you highlight the “Wake Up Control” label and then press the enter key, it will display a submenu
with the following options:
PWRON After PWR-Fail
This option determines whether you want to restart the system after a power failure. Select “On”, to
boot the system whether or not the system was on before power failure. Choose Former-Sts, to restore
the system to the status before the power failure.
Options: Off (default)
、
On
PS2KB Wakeup Select
Use this option to configure the PS2 keyboard Wake Up feature.
“Password” Use this selection to force the user to enter a password after the system awakens
from PS2 keyboard activity.
“Hot Key” Use PS2KB key to awake the system. See “PS2KB Wake Up from S3-S5” to configure
the hotkey.
PS2KB Wake Up from S3/S4/S5
This option is used when “PS2KB Wake Up Select” is configured as “HOT KEY”.
Options: Disable (default), Ctrl+F1(to F12), Power, Wake, Anykey.
USB Wake Up from S3
This item allows you to awaken the system from suspend mode using a USB keyboard. Options:
Enabled
、
Disabled (default)
VGA
When set to “On”, any event occurring at a VGA Port will awaken a system which had been previously
powered down. Options: OFF (default)
、
On.
LPT & COM
When this option is set to On, any event occurring at a COM(serial)/LPT (printer) port will awaken a
system which has been suspended. Options: LPT/COM (default)
、
COM
、
LPT
、
NONE
HDD & FDD
When set to “On”, any event occurring on a hard drive activity or a floppy drive activity will awaken
the system which had been previously suspended. Options: ON (default)
、
OFF
PCI Master
When set to “On”, you need a LAN add-on card which supports the power on function. It should also
support the wake-up on LAN jumper. Options: OFF (default)
、
ON
39
