Albatron PI960GLE, Руководство пользователя

Страница: 17 / 35

Mainboard PI960GLE
13
Speaker Header: SPK1
A speaker cable on your case front panel can be attached to this header. When you reboot the computer,
this speaker will issue a short audible (beep). If there are problems during the Power On Self-Test, the
system will issue an irregular pattern of audible beeps through this speaker.
Connectors
Hard Disk Drive Connector: IDE1
The mainboard provides one IDE connector that supports Ultra ATA 133/ 100/ 66/ 33 IDE devices. You
can attach a maximum of two IDE devices, such as hard disk drive (HDD), CD-ROM, DVD-ROM, etc. using
IDE ribbon cables.
In general, two IDE devices can be attached onto one IDE connector. If you attach two IDE HDDs, you
must configure one drive as the master and the other one as the slave.
Serial ATA Connector: SATA 1/2/3
The three SATA connectors support 3 Gbps data transfer rates, and one SATA connector only can attach
one SATA HDD of each time using SATA cables.
LVDS Connector: LVDS
This mainboard supports one 24-bit LVDS (Low Voltage Differential Signaling) connector. You can attach
one flat panel display or other compatible display device.
Pin Assignment Pin Assignment
1 PC_BEEP 2 N/A
SPK1
3 Ground 4 +5V