Mainboard KM51PV-754
29
Onboard I/O Chip Setup
If you highlight the “Onboard I/O Chip Setup” label and then press the enter key, it will take you
to a submenu with the following options:
P
H
O
O
O
P
E
E
P
ower On Function
This option allows you to select a method of awakening the system from sleep mode.
Options: Hot KEY, Mouse Left, Mouse Right, Any KEY, BUTTON ONLY (Default), and
Keyboard 98.
ot Key Power ON
This option allows you to use the Ctrl key along with a hot key (function key) to power on your
system. This option is configurable only when “Power-On Function” is set to “Hot Key”.
Options: Ctrl-F1 (Default), Ctrl-F2…… Ctrl-F12.
nboard FDC Controller
Select “Enabled” if your system has a floppy disk controller (FDC) installed on the system board
and you wish to use it. If you install an add-in FDC or the system has no floppy drive, select
“Disabled”. Options: Enabled (Default), Disabled.
nboard Serial Port 1
Select an address and corresponding interrupt for the first/ second serial port.
Options: Disabled (Default for port1), 3F8/IRQ4, 2F8/IRQ3 (Default for port2), 3E8/IRQ4,
2E8/IRQ3, Auto.
nboard Parallel Port
Select an address and corresponding interrupt for the onboard parallel port.
Options: 378/IRQ7, 278/IRQ5, 3BC/IRQ7, Disabled (Default).
arallel Port Mode
This option allows you to select a parallel port mode for the onboard parallel port.
Options: ECP(Default) Extended Capabilities Port.
EPP Enhanced Parallel Port.
SPP Standard Printer Port.
ECP+EPP ECP & EPP mode.
Normal
PP Mode Select
Select EPP port type 1.7 or 1.9. This field is only configurable if “Parallel Port Mode” is set to
“EPP” or “ECP+EPP”. Options: EPP 1.9(Default), EPP 1.7.
CP Mode Use DMA
Select a DMA Channel for the parallel port when using the ECP mode. This option is only
configurable if “Parallel Port Mode” is set to “ECP”. Options: 3 (Default), 1.
WRON After PWR-Fail
This option will determine whether your system will boot after restoring power after a power
failure. If you select “On”, the system will boot whether or not the system was on before power
failure. If you select “Former-Sts”, the system will be restored to the status before the power
failure. Options: Off (Default), On, Former-Sts.
