Part N
umber
6410T0006
Version 4/23/2010
32
ADJUSTMENTS
Adjustments to the photo amplifier box will be required at installation of the C.S.E. and may also require
periodic adjustments. (
See Figure 31
)
1.
Activate door and stop it at a central location (i.e. 5 feet off the ground) using the
EMERGENCY
STOP
button.
2.
Ensure the range selector switch is in the up position (long range).
3.
Ensure the operation selector switch is in the bottom position (light operated).
4.
Ensure green power LED and the red relay activated LED are on. If the relay activated LED if off,
then rotate the gain knob clockwise until it turns on. At this point, turn the knob slightly more to
ensure a stable operation.
5.
Place an object (i.e. tool) underneath the door reversing edge to break the photocell beam. The red
relay activated LED should turn off. If it does not, then rotate gain knob counter clockwise until LED
turns off. Rotate the gain knob back clockwise until it turns on. At this point, rotate the knob slightly
more to ensure a stable operation.
6.
Check photocell operation again to ensure it is functioning properly. When finished making
adjustments, pull out
EMERGENCY STOP
button.
NOTE
IF RED RELAY ACTIVATED LED IS
NOT ON, THEN THE DOOR WILL
OPEN AND STAY IN THE OPEN
POSITION UNTIL THIS CONDITION
IS CLEARED.
NOTE
THE CSE’S ARE “T” MARKED ON
FOR THE TRANSMITTER
AND A “R” FOR THE RECIEVER
TELCO
FIGURE 31
FIGURE 31
Содержание RAPID-ROLL 570
