Albalá Ingenieros IPA3000C01, Руководство пользователя

Страница: 20 / 46

Albalá Ingenieros | Manual IPA3000C01
In the INPUT FAIL box:
ASI MAIN,
ASI RES,
IP MAIN,
IP RES:
Red. These LEDs light up to indicate errors for the corresponding input.
They light up continuously when no signal is present, when the frame
synchronization fails or when the megaframe synchronization fails (this
last error is only in DVB-T mode) or when an external error has been
signaled via GPI.
In DVB-T mode these LEDs will blink when the TS delay is greater than the
value established for the output.
These LEDs remain off if no errors are present or if the corresponding
input is disabled.
1PPS / 10MHz: Red. These LEDs light up to indicate errors in the 1 PPS or the 10MHz
reference inputs. They light up continuously whenever the signal at the
corresponding input is invalid.
In the ETHERNET box:
LINK: Green. This LED lights up continuously when a link has been established
via the Ethernet port.
ACT: Green. This LED blinks when there is activity on the Ethernet port.
1G / 100M: Green. These LEDs light up to indicate the speed of the Ethernet interface.
1G indicates a speed of 1Gbit/s. 100M indicates a speed of 100Mbit/s. If
both of these LEDs are off and the LINK is lit the speed is 10Mbit/s.
In the INPUT SELECTION box:
ASI MAIN,
ASI RES,
IP MAIN,
IP RES:
Green. These LEDs indicate which input TS is being delivered to the
output.
In the MODE box:
AUTO,
HALF AUTO,
MANUAL:
Green. These LEDs indicate which operating mode is selected.
SEAMLESS: Blue. This LED lights up when seamless switching is possible. During
Automatic and Semiautomatic modes this LED lights up when seamless
switching is possible between the active input and the highest priority
input of the remaining three inputs. In manual mode this LED lights up if
a seamless switching is possible when the SELECT is pressed.
20