Alarm.Com Building 36 ADC-T3000, Руководство пользователя

Страница: 13 / 20

Thermostat Z-Wave Specification June 26, 2019
Building 36 Technologies
An Alarm.com Company
13
5.1.38 0x26 : Z-Wave Association Report Bit Mask
•
Bitmask to selectively enable non-required Z-Wave association reports. The report is
enabled if the bit is set to one (1).
o
Bit 0 – Thermostat Mode
o
Bit 1 , 2 – Reserved
o
Bit 3 – Thermostat Operating State
o
Bit 4 – Thermostat Fan Mode
o
Bit 5 – Thermostat Fan State
o
Bit 6 – Ambient Temperature
o
Bit 7 – Relative Humidity
o
Bit 8 – Reserved
o
Bit 9 – Battery Low Notification
o
Bit 10 – Battery Very Low Notification
o
Bit 11- Thermostat Supported Modes
o
Bit 12 – Remote Enable Report
o
Bit 13 – Humidity Control Operating State Report
o
Bit 14 – HVAC Type
o
Bit 15 – Number of Cool/Pump Stages
o
Bit 16 – Number of Heat/Aux Stages
o
Bit 17 – Relay Status
o
Bit 18 – Power Source (C-Wire or Battery)
o
Bit 19 – Notification Report Power Applied
o
Bit 20 – Notification Report Mains Disconnected
o
Bit 21 – Notification Report Mains Reconnected
o
Bit 22 – Notification Report Replace Battery Soon
o
Bit 23 – Notification Report Replace Battery Now
o
Bit 24 – Notification Report System Hardware Failure
o
Bit 25 – Notification Report System Software Failure
o
Bit 26 – Notification Report System Hardware Failure with Code
o
Bit 27 – Notification Report System Software Failure with Code
o
Bit 28 – Display units (C/F)
o
Bit 29 – Heat Fuel Type
o
Bit 30 – Humidity Control Mode
o
Bit 31 – Humidity Control Setpoints
•
Default is 0xFFFFFFFF
•
Size 4 byte