BDDF00144 Issue 1
11/40
Alaris™ GW 800 Volumetric Pumps
Getting Started
Getting Started
w
Before operating the Pump read this Directions For Use (DFU) manual carefully.
Initial Set Up
1 . Check that the Pump is complete, undamaged and that the voltage rating specified on the label is compatible with your AC power
supply .
2 . Items supplied are :
• Alaris GW 800 Volumetric Pump
• Electronic Instructions For Use Insert
• User Support CD (Directions For Use)
• AC Power Cable (as requested)
• Protective Packaging
3 . Connect the Pump to the AC power supply for at least 2½ hours to ensure that the internal battery is charged (verify that the
S
is
lit) .
w
The Pump will automatically operate from its internal battery if the Pump is switched on without being connected
to the power supply.
Should the Pump fail to perform correctly, replace in its original protective packaging, where possible and contact
Qualified Service Personnel for investigation.
Power Input
The Pump is powered from the AC supply through a standard IEC AC connector . When connected to the AC supply the AC Power
indicator is illuminated .
w
• To isolate the Pump from AC supply remove the AC connector from the source socket.
• The Pump should be positioned to allow access for disconnecting the AC connector.
