Alamo Schulte SRW 1400, Руководство оператора

Страница: 33 / 83

© 2004
Alamo Group Inc.
ASSEMBLY
ASSEMBL
Y
Assembly Section 3-5 SRW1400 10/04
Light Kit
The pivoting action of the SRW 1400 enables the implement to decrease its transport width to under 3 metres,
thereby eliminating the need for additional lighting for width. However, should the implement be used for reclaiming
gravel from roadsides, a light kit is required.
Installation of Left Light Bar
1. The left light bar is the shorter of the two.
2. Locate the light bar as shown in figure 3-6.
3. Place a backing plate on opposite side of tube from light
bar.
4. Insert the 3/8" x 3" bolts provided through backing plate and
light bar. Secure with 3/8" locknuts provided.
Installation of the Right Light Bar
1. Locate the light bar as shown in figure 3-7. The light bar
should be positioned as close to the back of the machine as
possible.
2. Place backing plate on opposite side of tube from light bar.
3. Insert the 3/8" x 3" bolts provided through backing plate and
light bar. Secure with 3/8" locknuts provided.
Installation of Lights
1. Install the lights onto the light bars using 5/16" hardware provided. Ensure that the red lights are inside and
facing to the rear as shown in figures 3-6 & 3-7.
Wiring Harness
1. Feed a length of wire through the hitch pole where the
wiring harness will go. See figures 3-8 & 3-9
2. Fasten the wiring harness to the wire at the front end of the
hitch pole.
3. Gently pull the wiring harness through the hitch pole. You
may need to loosen the hydraulic line mountings to facilitate
this.
4. The wiring harness should enter the hitch pole as shown in
figure 3-8 and exit as shown in figure 3-9.
5. he short leg of the wiring harness should go to the lights on
the right side of the machine. Plug the wiring harness into
lights following the color coding on the wiring harness.
6. Ensure that the wiring harness will not limit the machine’s
range of movement and use the wire ties provided to secure
the wiring harness. Use figures 3-6 through 3-9 as a guide
for final placement of the wiring harness and the wire ties.