Alamo RX96, Руководство оператора, Страница: 93 / 172

ASSEMBLY
RX96 03/09 Assembly Section 3-9
© 2009 Alamo Group Inc.
ASSEMBL
Y
DRIVELINE ATTACHMENT
Before starting assembly, make certain that all paint, dirt, and grease are removed from gearbox shaft (1). To
ease assembly apply a light coat of grease to splines and assemble. Do not assemble a driveline without a
shield.
(Figure Asm-R-0129)
Attach the slip clutch end of the driveline to the gearbox input shaft securely. Make certain that the slip clutch is
fully onto the input shaft splines. Tighten the locknuts (2) alternately until they have reached the proper torque.
Refer to Torque Chart in Maintenance Section.
)
SHIELD ASSEMBLY - Side Drives - Lift and Pull
Attach the Brackets (1& 2) to the Gearbox. Install
Shield (3) to brackets (1 & 2) with Bolt (4)
Flatwashers (5) and locknut (8). Close Shield and
retain with Bolt (6), Flatwasher (5) and with Thumb
nut (7).
(Figure Asm-R-0297) Proceed to attach
Divider Shield (1) with bolt (2) and Lockwasher (3).
Retain Divider Shield with Thumb Nut (4) and
Flatwasher (5).
(Figure Asm-R-0298
SHIELD ASSEMBLY - Main Input - Lift and Pull
Attach the Bracket (1) to the Center Gearbox with
M10 x 35 Bolts (2), and Flatwasher (3). Install
Shield (5) and retain with 1/2” Wing Nut (4).