Alamo RX96, Руководство оператора, Страница: 142 / 172

OPERATION
RX96 03/09 Operation Section 4-46
© 2009 Alamo Group Inc.
OPERA
T
ION
Gearbox Leaking Damaged Oil Seal Replace Seal.
Bent Shaft. Replace Oil Seal and Shaft.
Oil Seal Race rough. Replace Shaft or repair Race.
Oil Seal installed wrong. Replace Seal.
Oil Seal not sealing in the housing. Replace Seal or use a sealant on O.D.
of Seal.
Oil level too high. Drain oil to proper level.
Gasket damaged. Replace Gasket.
Bolts loose. Tighten Bolts.
No Oil Seal Install Oil Seal
Oil too light. Use EP140.
Bearings loose. Adjust Bearings.
Vent Plug stopped up. Open Vent Plug.
No oil seal. Install oil seal.
Oil too light. Use EP140.
Oil level too high. Drain oil to proper level.
Gasket damaged. Replace gasket.
Bolts loose. Tighten bolts.
Rapid Clevis Wear Washers not used. Install washers above & below drawbar
Clevis bending or spreading Using pin or bolt not tightened. Use 1” gr5 or 8 bolt & tighten nut.
open.
Tongue bending or binding Improper Drawbar. Add attaching Plate to all 3-Point
in turns. drawbars.
Breaking Blade Bolts Operating with loose Blade Bolts. Tighten Blade Bolts to 300 ft./lbs
(Right Hand threads)
Worn Blade Bolt. Replace Bolt.
Cutting Too High Blades bent up. Replace Blades.
Blade Carrier bent. Straighten or replace Blade Carrier.
Blades on upside down. Turn Blades right side up and tighten.
Mower Windrowing Cutting heavy material. Raise mower and reduce
ground speed.
Broken Cross or Cups Load too high for joint. Use protective device with joint.
Check joint angles and phasing.
Slow down or raise Mower.
(See Clutch Maintenance)
End Galling of Cross Speed too high during turns. Reduce PTO speed.
and Cups