Repair Manual 1
Version 1.00
Version 1.00
Stages of system check:
1. Check that there is no short circuit anywhere, and that the fuses are intact. Also check
that voltage is present in the system.
2. Check the conductivity of all connections by measuring.
3. Check the spindle motor by running it directly with a battery. Connect the + and – wi-
res to the battery terminals and make sure that the spindle motor moves.
4. If the fault has not been detected yet, it is probable that the adjustment potentiometer
or the electronic unit is malfunctioning. These components cannot be measured easily,
instead they must be tested by trying them.
Replace with a component that definitely works, and test whether the system functions.
7.1. Installation Instructions
1.
The control system has been preadjusted as in drawing SE-01 (appendix 1).
2. If the water jet unit has already been installed on the boat, the installation of the
reversing deflector control system can begin.
2.1. Set the reversing deflector in centre position so that lever 5 (figure SE-01)
points up perpendicularly.
2.2. Fix the spindle motor (part 4) in place implementing the setting dimension
of 413 mm (figure SE-01). The spindle motor can point perpendicularly
either to the right or left. Note that the
spindle motor is locked with steel
wire
to prevent the spindle from rotating.
2.3. Make sure that the dimension of 100 mm is implemented as indicated in
figure SE-01.
2.4. Attach the control box (part 3, figure SE-01 ) as close to the spindle motor
as possible in vertical position with connection cables down.
2.5. Fix the control lever (part 1) in place, connect the control cable
to the connection box (part 2), and then to the control cable (part 3.1).
2.6. Connect the power supply cable to the connection box (part 3.3, not incl.
in the delivery). The size of the power supply cable must be 2 x 4 mm
2
.
Fuse 16 A.
3.
Make sure that the control lever is in centre position and switch on the current to
the equipment.
4.
Move the control lever carefully and at the same time observe the course of the
reversing deflector.
5.
If the course of the deflector is different than desired, the course can be altered
in accordance with the accompanying adjustment instructions.
6.
If you start to adjust the course of the deflector, familiarize yourself with the ad
justment instructions first.
GUARANTEE CLAUSE: The guarantee is valid only if instructions
for installation and adjustment have been followed!
WARRANTY
