Version 1.00
11
Repair Manual 1
Version 1.00
Version 1.00
2.1.1.1 Jet-180/185
In removing the shaft, the Jet-180/185 requires the same procedures as the Jet-160.
Open the fastening screws of the support bearing housing (4 pcs) and remove the sup
-
port bearing housing (figures 2.1.1.2-1 and 2.1.1.2-2).
The actual bearing housing is attached to the body with sealing and
adhesive compound. It is not necessary to remove it, unless it is dama-
ged.
Figure 2.1.1.2-1
Figure 2.1.1.2-2
The shaft protrudes into the engine
room with the bearings. The fit may be
tight, but when pushed from the outsi-
de, enough force is produced to remo-
ve the shaft (figure 2.1.1.2-3).
Figure 2.1.1.2-3
