AL-KO COMBI-CARE 38 E comfort, Перевод оригинальной инструкции по эксплуатации

Страница: 17 / 180

17
474397_d
GB
Setting the working depth (04)
Important!
Only set the working depth if the motor is switched
off and the blade shaft is stopped.
Set the working depth of the blade shaft at the dial
selector.
1. Tilt the scarifier backwards with the handlebar.
2. Push the twist switch down and turn it to level "1".
Positions on the dial selector:
1 - 5 = Setting the working depth (04)
With new blades, set the dial selector to posi-
tion 2 at most!
The correct working depth depends on:
„
the condition of the lawn
„
the wear on the blades
If the working depth is set too low:
„
the scarifier will stop
„
the motor will stall
In this case, move the dial selector back to a shallower
working depth.
Always mow the lawn before scarifying.
Start the motor (06)
1. Push and hold the button of the safety pushbutton
switch (a).
2. Pull the operator presence control against the
handlebar (b). The motor starts.
The operator presence control does not lock in
place. It must be held in place all the time.
3. Release the button of the safety pushbutton
switch.
Switching off the motor (07)
1. Release the operator presence control (a). It auto-
matically returns to its initial position. The motor
is switched off.
Danger of lacerations!
The blade shaft keeps turning under its own
momentum! After switching off, do not reach
under the machine straight away.
Hooking in/unhooking the grass catcher
1. Switch off the motor before hooking in/unhooking
the grass catcher.
2. Wait for the blade shaft to come to a stop
General notes on operation
„
The blade system must be able to turn entirely
freely in order for the machine to be started
„
Keep the power cable out of the working area
„
Only control the machine using the handlebar. This
ensures the necessary safety clearance.
„
Be particularly careful when turning the scarifier or
pulling the machine behind you
„
Make sure you can stand securely on slopes
„
Always scarify across the slope
„
Never scarify on steep slopes
„
Always scarify at walking pace
„
Never tilt or transport the machine when the motor
is running
„
Have the machine checked by a specialist if the
following events occur:
„
After running into an obstacle
„
if the motor stops suddenly
„
If a blade is bent
„
If the blade shaft is bent
„
If the V-belt is defective
Maintenance and care
Danger!
Risk of injury on the blade shaft.
Wear protective gloves!
Do not open the engine housing.
Maintenance of the engine must be done by an
authorised specialist workshop.
„
Disconnect the mains plug before any mainte-
nance and cleaning work! Wait for the shaft to
come to a stop.
„
Only use genuine spare parts.
„
Only renew worn or damaged implements and
pins as a set, in order to avoid imbalances.
„
Do not spray the equipment with water!