AL-KO 112660, Руководство пользователя

Страница: 11 / 77

GB
470512_a
11
Assembly
Scope of supply
1x operating instructions
„
1x assembly instructions
„
1x upper bar
„
2x lower bar
„
1x grass catcher, upper part
„
1x grass catcher, lower part
„
1x baf fl e
„
2x front wheel / wheel cap Ø 125 or 150
„
2x rear wheel / wheel cap Ø 150 or 180
„
1x bag of screws
„
1x cable holder
„
1x cable strain relief
„
Assembly sequence
See illustrations in the assembly instructions.
Assembly of baf fl e (a - c)
1
Assembly of baf fl e
Insert the bearing rod of the baf fl e. 1.
Pull left-hand / right-hand springs forward until 2.
they engage.
Secure the baf fl e holder with a Ø 4,2x15 screw. 3.
Assembly of the bars
2
Assembly of lower bar in housing
Insert lower bar into the recesses as far as the 1.
stop and secure on each side with a Ø 4,8x16
screw.
3
Assembly of upper bar on lower bar (a - c)
Push on cable strain relief. 1.
Fasten upper bar to lower bar with screw and 2.
wing nut.
4
Assembly of bearing components on upper bar
(a - c)
Push on cable fi xing clamp. 1.
Mount switch/connector combination with 2 2.
screws Ø 4x25.
Assembly of wheels (a - c)
5
Assembly of wheels
Push wheel onto axle until it clicks into place. 1.
Insert axle at desired cutting height. 2.
Holding onto the fi rst wheel, push on the se- 3.
cond wheel. This wheel must also click into
place.
Assembly of grass catcher
6
Assembly of grass catcher parts
Push the upper part onto the pins of the lower 1.
part of the grass catcher.
7
Securing the grass catcher parts
Close both parts of the grass catcher together 1.
and secure with 2 Ø 4,2x15 screws.
Attaching the grass catcher
Lift the baf fl e. 1.
Lift the grass catcher and attach it in place. 2.
Press the baf fl e. 3.
Handling
Adjusting the cutting height (a - c)
With the button pressed, pull off the wheel. 1.
Pull out the axle and reinsert at the desired 2.
cutting height.
Push wheel back on until it clicks into place. 3.
Adjust the second axle in the same way. 4.
8
9