Akrobat GALLUS INGROUND, Инструкция по установке и эксплуатации

Страница: 6 / 20

6 INSTALLATION AND USER MANUAL - GALLUS INGROUND
Digging the trampoline pit
Position the frame on the location you chose and mark the position on the ground. It’s best to mark
out a hole a bit wider than the diameter of your trampoline.
This will make it easier for you to put the frame in and find the right level. Dig the pit to the
following dimensions:
First, dig the outer hole to create a ledge for
your trampoline frame, which needs to be
25cm deep. This is the exact frame height, so
that the safety pad on top of the frame will be
just above the grass level. Continue by digging
the inner hole.
Dig out in a bowl shape to a depth of 75
cm (10ft & 12ft trampolines) , or 90 cm
(13.5ft & 14ft trampolines) . The inner hole
should be 40 cm narrower in diameter than
the trampoline, which leaves a 20 cm ledge all
around to place the trampoline.
TRAMPOLINE SIZE
Dimension A – Outer hole Dimension B – Inner hole Dimension C – Total depth
10 ft / cca. 305 cm 204 cm 75 cm
12ft / cca. 366 cm 264 cm 75 cm
13.5ft / cca. 411 cm 371 cm 90 cm
14ft / cca. 427 cm 387 cm 90 cm
4
Attaching the pvc retaining panels
The next step is screwing the PVC retaining
wall panels to the frame. You will need the
cross-head screwdriver and gloves. Take one
panel and place it against the outside of the
frame. You will find four holes in the frame and
four holes in the wall panel. Insert and tighten
the four screws to attach the panel tightly to
the frame. Repeat with all remaining panels.
3
AKROBAT HINT:
It’s a relatively easy task to hand dig the hole for smaller size trampolines, but it would be best to hire a
mini digger able to excavate most of the soil and leave you with the finishing touches.
Note: You will need to save some of the soil for later.