2 Description
2.4.2 Rear Panel
Fig. 2: Rear panel controls on
SR 40 FLEXX receiver.
2.5 HT 40 FLEXX
Handheld Transmitter
2.5.1 Controls
Refer to fig. 3 on page 2.
Note:
9 Carrier frequency label:
A label indicating the name of the carrier frequency band and
the three carrier frequencies of your receiver is affixed to the rear panel of the receiver.
10 AUDIO OUT/BALANCED:
Balanced 3-pin XLR audio output for connecting to, e.g., a mi-
crophone input on the mixing console.
11 AUDIO OUT/UNBALANCED:
Unbalanced audio output on a 1/4" TS jack for connecting
to, e.g., a guitar amplifier.
12 Strain relief
for the feeder cable of the supplied AC adapter.
13 DC ONLY:
Input connector for the supplied AC adapter.
14 SQUELCH:
The squelch circuit switches the receiver off if the received signal is too
weak, in order to suppress the related noise or the residual noise of the receiver while
the transmitter is off. Set the SQUELCH control to minimum before first switching the re-
ceiver on.
Operating in the 660 MHz to 865 MHz UHF range, the HT 40 FLEXX provides three selec-
table, quartz stabilized carrier frequencies within the 3-MHz-wide frequency band for which
you ordered your WMS 40 FLEXX. The antenna is integrated in the body.
The microphone element permanently mounted on the transmitter uses a high quality car-
dioid transducer from AKG. It provides low handling noise sensitivity, high gain before feed-
back, and brilliant sound quality, as well as a built-in wind and pop filter to reduce wind and
breath noise.
15 On/off switch:
This slide switch provides three positions:
ON:
Power to the transmitter is on.
MUTE:
The signal delivered by the microphone element is muted while power and the
RF carrier frequency remain on.
OFF:
Power to the transmitter is off.
16 Status LED:
Indicates the transmitter's operating status.
LED lit green:
Battery is OK.
LED lit red:
From the moment the LED changes to red, the battery capacity will provide
a maximum of two operating hours. We recommend replacing the battery with a new one
as soon as possible.
• If you use a rechargeable battery, the LED will change to red 15 minutes before the bat-
tery will be dead!
17 Frequency selector:
This slide switch tunes the transmitter to one of three different
carrier frequencies within the transmitter's carrier frequency band.
18 GAIN:
This slide switch sets the transmitter's audio input gain in two stages, "HIGH"
(high gain) or "LOW" (low gain).
25
WMS 40 FLEXX
9
10
11
12
14
13
BDA WMS 40 FLEXX 08_Hex:Layout 1 01/08/2008 15:52 Seite 25 (Schwarz/Black Auszug)