
If a fault occurs, first check the points listed below before taking the unit for repair. If you are unale to remedy a
problem by following these hints, consult your dealer or service center.
WARNING: Under no circumstances should you try to repair the unit yourself, as this would invalidate the
guarantee.
IMPORTANT: Due to continual revision and improvement on our product design,
specifications are subject to change without further notice.
Power Supply
AC120V~60Hz
DC 9V (LR14-1.5V x 6 pieces)
Power Consumption
13 W
Dimensions (H x W x D)
4.53” x 9.69” x 8.43”
(115mm x 246mm x 214mm)
Net Weight
3.15 lb (1.43 kg)
Radio Section
Frequency Coverage
FM: 87.5 - 108 MHz ; AM: 530 - 1710 kHz
Power Output
1 W x 2 (RMS)
Speaker Impedance
8 Ohms
PROBLEM
POSSIBLE CAUSE
REMEDY
No sound in general
Volume not adjusted.
Mains supply is not correctly
connected.
Adjust the Volume knob.
Connect the mains supply
properly.
The unit does reset to
operation of any button
Under the influence of
electrostatic phenomenon, the
product may malfunction and
require user to disconnect.
Turn off the unit, disconnect the
mains plug, and reconnect after
a few seconds.
Radio poor reception
Weak radio aerial signal.
Interference caused by the
vicinity of electrical
equipment like TVs, video
recorders, computer,
thermostats, fluorescent
lamps (TL) engines, etc.
Aim the aerial for best reception:
Fully extend the telescopic
antenna.
Keep the unit away from
electrical equipment.
CD cannot read
The disc is dirty.
The disc is upside down.
The CD player is in Pause
mode.
Clean or replace the disc.
Turn it over so that the label is
face up.
Release the Pause Mode by
pressing the Play/Pause button.
EN - 11
TROUBLESHOOTING
TECHNICAL SPECIFICATOIN