
EN - 9
To Program Specific Tracks (up to 20 tracks)
1. Load the CD you wish to program.
2. Make sure the CD is in stop mode.
3. Press the PROGRAM button once, “01” will display on the LED and PROGRAM indicator will blink.
4. Press the SKIP / buttons until the desired track number is reached.
5. Press the PROGRAM button to store the selection.
6. Repeat the (4) & (5) steps until you have entered all the tracks.
7. To play the stored sequence, press the PLAY / PAUSE button.
8. After all memory tracks have been played, the CD player will stop automatically.
NOTE:
1. When 20 tracks of CD have been programmed, the memory is full. The programmed tracks’ numbers will
show on the LED display sequentially. Then the location “01” shows on LED display and flashes. You can
press PLAY / PAUSE button to start the program playback. Or repeat (4) & (5) steps to change the
track number you wish.
2. If you want to cancel the program memory, press the STOP button twice during playback or once in
STOP mode.
The Repeat function also applies to programmed track playback.
To Repeat Programmed tracks
1. During program play, press REPEAT button once will repeat the specifically programmed tracks.
2. Press the REPEAT button again will repeat all the programmed tracks.
3. Press the STOP button twice to cancel program playback.
PROGRAM FUNCTION
LINE IN jack will allow you to connect external music player or external analogue sound source to the main
unit.
1. Plug a 3.5mm audio cable (not included) into your external music player and connect the other end
(3.5mm jack) into the LINE IN jack on the left hand side of the unit.
2. Make sure your external music player is turned on and the unit has been turned on (POWER indicator lights
up).
3. Slide the FUNCTION switch on the unit to LINE IN position. The unit will enter AUX mode automatically.
4. Start music playback on your external music player.
5. Adjust VOLUME knob to control the sound level of music playback from the speakers on the unit.
LINE IN OPERATION