34
released and the unit will enter the standard search mode. The current program
will be program
№1
. And the ground balance reference point will be(
0
).
ATTENTION!
The parameters for the coils are not reset and will be retained during a
factory reset
The factory program №1-
This program has the sensitivity set low which gives it
stable response to the ground and economic battery life (low coil current). It is intended
when searching for large or shallow objects. The discriminator is set to reject most
undesirable targets. The included filters suppress most of the unwanted signals.
The factory program №2
- This program has sensitivity set a bit higher than Prog.
1. Again this program is most useful in detecting medium to large targets and those targets
at shallow to medium depths as well as detecting in areas littered with trash.
The factory program №3-
This program has
higher sensitivity levels and is
intended for searching smaller objects that are deeper. In most cases it provides very
good depth while retaining a good quality of search. The coil current is set to TURBO
therefore power consumption is higher than in the first two programs.
The factory program №4
- This program has
high levels of sensitivity
and is
intended to search for deeply buried targets in areas with minimal levels of trash. In this
program it is important to slow the sweep speed and maintain a constant distance from the
ground without deviations. Also in this program the coil current is set to TURBO.
In program
№1
the
discriminator is for maximum rejection of unwanted targets.
Targets typically rejected include small ferrous objects, small pieces of foil and
aluminum wire. Typical targets that are accepted would be objects made from copper, silver
larger pieces of aluminum as well as other similar objects. This program may reject targets
that are desirable to you such as small gold or jewelry as well as some small hammered
coins.
In program
2-4
The
discriminator is set to reject small ferrous targets.
Remember that these programs are intended as a starting point to allow the user to become
acquainted with the device. For maximum efficiency of the detector the user will need to
adapt the programs to their search conditions.
Remember when adjusting any of the programs to try and have an understanding of
what the parameter is and how it will affect the detector in the field. Just because an
increased setting will result in improved air tests does not mean this will necessarily happen
under actual detecting conditions.
RECOMMENDATION!
At first power up factory programs will be installed.
REPLACING THE SEARCH COIL
If your detector is supplied with two or more search coils, configured to work
with your device, in order to replace them perform the following.
1. Turn off the detector.
36
37
