AJA Ki PRO ULTRA, Руководство по установке и эксплуатации

Страница: 52 / 98

Ki Pro Ultra v1.2r1 www.aja.com 52
8.1 TC VALUE
This parameter selects an hour value from which timecode begins incrementing. These
are the options:
8.2 TC TYPE
This parameter selects drop frame or non-drop frame timecode. These are the options:
NOTE: If the menu parameter 8.0 TC In is set to SDI RP188 or LTC, the TC Type selection does not
apply. TC Type only applies to the TC Value or the Time of Day value generated by the Ki Pro
Ultra.
8.3 ARM RECORDING
This parameter selects how recording may be initiated—either by pressing the physical
record button or by incrementing ststop timecode values. These are the options:
If arm recording on timecode, parameters 8.0, 8.1. and 8.2 must be set to a qualified
source and type of timecode. You should use timecode that starts and stops, like that
produced by record run timecode; freerun timecode is not viable for this feature since it
does not produce start and stop values.
9.0 INTERVAL RECORD
The Ki Pro Ultra can be used to create timelapse recordings via the 9.0 Interval Record, 9.1
Interval Frames and 9.2 Interval Time selections. These are the options:
Example of timelapse recording selections:
The incoming video signal is 1080i 29.97 fps, the record button is depressed, and the
recording is then stopped 90 seconds later with the following settings:
9.0 Interval Record > On
9.1 Interval Frames > 1
9.2 Interval Time > Second
The resulting recording would be 90 frames in duration, would have a frame rate of 29.97
fps, and would appear to be “undercranked” or “sped up” when compared to a normally
created recording.
NOTE: Selecting an interval frame number that exceeds the incoming video frames per second will
result in normal video. “Overcranking” or “slow mo” is not supported by the interval recording
feature.
9.1 INTERVAL FRAMES
Determines how many frames from the incoming video will be used for the recording.
These are the options:
00:00:00:00 to 23:00:00:00
(Default: 01:00:00:00) Use the User Control Knob to select a timecode hour.
For example: 01:00:00:00, 02:00:00:00, etc.
NDF (default)
DF Selects Non-drop Frame timecode
Selects Drop Frame timecode
REC KEY (default)
TC/REC KEY Start when Record button is pressed
Start on Time Code or Record button
OFF (default)
ON Normal recordings are produced.
Timelapse recordings are produced.
Incrementing Value Sets number of frames to use for the recording.