www.aja.com
114
FS4 Frame Synchronizer/Converter v1.1
Front Panel SNMP
Configuration
FS4 SNMP configuration can be accomplished using the front panel or with the web
browser computer interface (if Remote Control is enabled).
The FS4 front panel screens for SNMP are accessible through the CONFIG button. The
direct SNMP configuration screens are:
• 4.0 SNMP Enable
• 4.1 SNMP Trap Destination 1
• 4.2 SNMP Trap Port 1
• 4.3 SNMP Trap Destination 2
• 4.4 SNMP Trap Port 2
These SNMP direct configuration parameters are described later in this chapter.
Front Panel Octet Value
Entry Procedure
Set the octets (numbers between periods) values as follows:
1. Push
ADJUST
momentarily to enter edit mode.
2. Turn
SELECT
to select the octet you want to edit, indicated by blinking.
3. Turn
ADJUST
to enter the new value.
• If you need to revert to the previous setting (undo changes), push
SELECT
.
4. Push
ADJUST
momentarily to save and activate the new setting.
• If you want to revert to the default value, hold down
ADJUST
for 4 seconds.
Web Browser SNMP
Configuration
SNMP direct configuration settings are available on the Config screen of the web browser
interface.
Figure 38. Web Browser Config Screen SNMP Parameters