AJ Aircraft Acuity, Руководство по сборке

Страница: 7 / 24

aj-aircraft.com Page 6
Check the aileron position at the hinges and wing tip
again before gluing.
Start with the hinge near the wing tip. Flex the aileron
slightly and apply a few drops of thin CA glue to one side.
Flex the aileron to its maximum desired position. Then
glue the opposite side.
Close the gap between the aileron and wing to the
desired position at the fuselage end of the wing half. Flex
the aileron slightly and apply a few drops of thin CA glue
to both sides of the hinge. Again move the aileron back
and forth to check its position. Once the end hinges are
securely positioned you can apply a few drops of thin CA
to both sides of the remaining hinges.
Use the control horns from the “Wings” part bag.
Use sand paper to roughen the lower portion of the
control horns on both sides. This will help the epoxy
bond to the control horn parts.
Test fit the control horn in the slot. Trim or file the slot as
needed to achieve a snug fit.
The control horn should go in all the way in until the
shoulder contacts the aileron. The linkage hole in the
control horn should be aligned with the hinge centerline.
With the control horn in position apply masking tape
around it. This will help keep excess epoxy off the
covering.