AJ Aircraft Acuity, Руководство по сборке

Страница: 16 / 24

aj-aircraft.com Page 15
Install the elevator servo using the same procedure used
when assembling the ailerons.
Connect the servo to a receiver and power supply. Turn
on your transmitter. Set trim and sub trim to zero. Install
a servo arm on the servo about perpendicular to the
servo’s side. Use the transmitter’s sub trim to make it
exactly perpendicular to the side of the servo.
Attach a servo extension onto the elevator servo lead and
use a safety clip to secure the connection.
Install the servo into the fuselage and pre-drill for servo
mounting screws using a 1/16” drill. Install the servo with
the wood screws that came with your servos. Remove
the screws and servo. Apply a drop of thin CA glue into
each mounting screw hole. This will harden the wood
around the screws and provide a more secure
installation. (Allow the CA glue to dry before reinstalling
the servo.)
Assemble a ball link to each end of a connecting rod.
Connect a ball link to a servo horn and the elevator
control horn. Use a socket head screw, a flat washer and
a nylon lock nut. Check the length of the assembly to the
servo arm with the elevator level with the stabilizer.
Once the correct length of the assembly is found connect
it to the servo arm using the provided machine screws
washer and lock nut.
(Turn on the transmitter, receiver and servo while making
adjusting to the connecting rod. This will keep the servo
in its correct position.)