5
ENGLISH
SETTING THE CLOCK
When the AC cord is connected for the first time, the
b
SET
button flashes.
Set the time as follows while the power is off.
1 Press the
b
SET button.
The hour flashes.
2 Press the
g
DOWN or
h
UP button to
designate the hour.
3 Press the
b
SET button to set the hour.
The hour stops flashing and the minute starts flashing.
4 Press the
g
DOWN or
h
UP button to
designate the minute.
5 Press the
b
SET button to set the minute and
complete setting.
The minute stops flashing on the display and the clock starts
from 00 second.
To correct the current time
Press the POWER button to turn the unit off. Press the
b
b
b
b
b
SET
button and carry out steps 1 to 5 above.
To display the current time
Press the CLOCK button on the remote control. The clock is
displayed for 4 seconds.
However, the time cannot be displayed during recording.
To switch to the 24-hour standard
Press the CLOCK button on the remote control and then press
the
a
CLEAR button within 4 seconds.
Repeat the same procedure to restore the 12-hour standard.
If the clock display flashes
This is caused by a power interruption. The current time needs
to be reset.
If power is interrupted for more than approximately 24 hours,
all settings stored in memory after purchase need to be reset.
BEFORE OPERATION
To turn the unit on
Press one of the function buttons (TAPE, TUNER, VIDEO/
PHONO/AUX, CD).
Playback of the inserted disc or tape begins, or the previously
tuned station is received (Direct Play Function).
The POWER button is also available.
The disc compartment may open and close to reset the unit.
DEMO (Demonstration) mode
When the AC cord is connected for the first time, the display
window demonstrates the functions of the unit. When the power
is turned on, the DEMO display is overridden by the operation
display. When the power is turned off, the DEMO mode is
restored.
To cancel DEMO mode
Press the DEMO button. To re-activate, press again.
Illumination guides
Whenever the AC cord is connected or one of the function buttons
is pressed, the buttons for that operation light up or flash.
Example: When the AC cord is connected, the
b
SET button
flashes as a guide to setting the current time.
Flash windows
The window on the top of the unit and the cassette decks light
up or flash while the unit is being powered on.
To turn off the light of the top window, press the
a
CLEAR button
while pressing the CD button. To turn back on, repeat the above.
To turn off the light of the cassette decks, press the
a
CLEAR
button while pressing the TAPE button. To turn back on, repeat
the above.
After use
Press the POWER button to turn off the power. The display
changes to the clock.
