B
completely (ideally about 20 seconds).
Continuous shock or vibration may cause the sound to be interrupted even if
the E•A•S•S 2
×
function is activated. This is normal and not a malfunction.
Should you experience an interruption in sound, stabilize the unit for a few
seconds, then resume your activity.
• When the E•A•S•S 2
×
function is activated, motor noise is heard as the motor
periodically rotates at high speed during playback. This is not a malfunction.
• When the E•A•S•S switch is slid during playback, the unit will pause for about
2 seconds.
• When you set the E•A•S•S switch to the OFF position, the quality of the sound
will be better than the case that you set it to the ON position.
Resume function
→
M
Set the HOLD switch to RESUME.
appears, and you can start playback from the point where you stopped
playback by pressing
s
STOP/OFF/CHARGE.
When the resume function is on, all-track repeat is selected automatically.
To cancel resume play, set the HOLD switch to OFF.
Note
• Resume play may start at a point about 30 seconds behind or ahead the stopped
point. Resume play may not operate if you stopped at the last 30 seconds of
the final track.
• Resume play will be canceled if you open the disc compartment. If the unit is
turned off, resume play will not be canceled. In this case, be sure to set the
HOLD switch to OFF before changing discs.
Random play
→
M
Press PLAY MODE while in standby mode to display
.
Tracks on the disc are played in random order.
To cancel random play, press PLAY MODE while in standby mode.
display changes to
.
Note
• You cannot back to previous track by pressing
r
during random play.
• You cannot select one-track repeat during random play.
Repeat play
→
M
Press PLAY MODE during playback to select repeat play as follows.
: one-track repeat
V
: all-track repeat
V
no repeat play (normal play)
PROGRAM PLAY
→
N
Up to 24 tracks can be chosen for program play.
1 Press ENTER/DISP while in standby mode to display “P-01”.
2 Select the desired track by pressing
r
and
t
.
a
track number
b
program number
3 Press ENTER/DISP within 8 seconds.
If it is not pressed within 8 seconds, the track number changes to 00. Repeat
the procedure from step 2 again.
4 Repeat steps 2 and 3 to program more tracks.
5 Press
e
PLAY/PAUSE to start program play.
To stop program play
Press
s
STOP/OFF/CHARGE.
To add tracks to the program
Repeat steps 2 and 3 before you proceed to step 5. You can add tracks to the
end of the program.
To erase the program
Press
s
STOP/OFF/CHARGE while in standby mode.
To check the programmed tracks
Press ENTER/DISP repeatedly before you proceed to step 5.
The number of each programmed track will be displayed in order of playback.
Note
• The program is also erased when the disc compartment is opened or the auto
power off function turns the power off.
• When 24 tracks are programmed, “P-FULL” appears, and no more tracks may
be added.
• You cannot back to the previous track by holding
r
pressed during program
play.
• Repeat play and random play can be performed during program play.
N
1
2
3
ENTER/DISP
ENTER/DISP
L
M
PLAY MODE
5
