USING ON RECHARGEABLE BATTERIES
→
E
You can use on rechargeable batteries, which you charge using an AC adaptor.
Rechargeable batteries and an AC adaptor are commercially available.
• Be sure to use size AA Ni-Cd 1.2 V 700 mAh rechargeable batteries.
• Be sure to use an AC adaptor whose rated output is DC 5 – 6 V, 250 – 300 mA.
• Be sure to read instructions of the purchased AC adaptor and rechargeable
batteries before use.
• When using on rechargeable batteries for the first time, charge them until the
battery indicator goes out.
• Before charging the batteries, close the disc compartment. You cannot charge
the batteries while it is opened.
1 Insert the rechargeable batteries with the
0
and
9
marks correctly
aligned.
2 Connect the AC adaptor.
1
to DC 5 ~ 6 V jack
2
to a wall outlet
3 Keep
s
STOP/OFF/CHARGE pressed for about 1 second to start charging.
“C-On” appears, and the battery indicator blinks.
When charging is completed, “C-OFF” flashes a few times, and the battery
indicator goes out.
After charging, disconnect the AC adaptor.
Time to recharge the batteries
Recharge the batteries when
lights. If the unit remains in use after
lights, “Lo-bAtt” appears and the current operation stops.
To stop charging
Press
s
STOP/OFF/CHARGE during charging.
Force charging
When the recharging stops after only few minutes or the batteries cannot be fully
recharged, press
s
STOP/OFF/CHARGE while pressing PLAY MODE to start
force charging.
ATTENTION:
The product you have purchased can be powered by
nickel cadmium batteries which are recyclable. At the
end of their useful life, under various state and local
laws, it is illegal to dispose of these batteries into your
municipal waste stream.
Please call 1-800-289-2492 for information on how to
recycle these batteries.
USING ON AC HOUSE CURRENT
Use only an AC adaptor whose rated output is DC 5 – 6 V, 250 – 300 mA.
Connect the AC adaptor in the same way as when recharging the batteries.
During operation on AC house current, all of the battery indicator disappears.
BEFORE PLAYBACK
HOLD switch
→
F
Release the HOLD switch before playback.
→
a
When not using the unit, set the HOLD switch to the HOLD position.
→
b
Accidentally pressed button will not function.
If buttons are pressed when the HOLD switch is set to the HOLD position, “HOLd”
flashes in the display.
Turning on and off
→
F
Turning the power on
Press
e
PLAY/PAUSE. Power is turned on and playback starts.
Note
“Err” appears on the display when you play a disc placed upside-down or a
defective disc.
Turning the power off
If no new operations are done within 30 seconds from the end of last operation,
the power is turned off automatically. (Auto power off function)
• You can turn off the power by pressing
s
STOP/OFF/CHARGE before it is
automatically turned off.
Standby mode
→
F
When an operation finishes, the unit goes into standby mode until the auto power
off function automatically turns off the power.
To enter standby mode, press
e
PLAY/PAUSE to start playback, then press
s
STOP/OFF/CHARGE.
Adjusting the sound
→
G
Volume
Turn the VOL control to adjust the volume.
DSL
Press DSL repeatedly for more powerful sound and deeper bass.
: Deep bass is emphasized.
: Deep bass is strongly emphasized.
: Normal sound
E
1
2
3
F
G
H
1
DSL
2
3
I
