7
ENCLOSURE ASSEMBLY
Refer to PARTS LIST for identification of parts.
1
Slide upper pole onto lower pole. Align
the set screw holes.
2
Insert small set screw and lock washer
& tighten. Repeat this procedure with all
remaining poles.
3
Starting from the upper pole, slide 2
foam tubes over pole assembly as
shown. Repeat with remaining poles.
WARNING:
2-3 adults in good physical condition are required for the following assembly. Wear proper shoes and maintain
balance to prevent a fall. Failure to follow all instructions and warnings exactly may result in serious injury.
4
Lay out the safety enclosure mesh as
shown. Tie straps must be on the outer
surface of mesh.
6
Place pole cap at top of upper pole
assembly and align pole cap bolt
holes. (Foam tubes should be pushed
up snug in the cap with no gaps.)
7
Place strap with grommet over hole in
pole cap. Align the holes.
8
Insert pole cap bolt as shown and
secure with nut.
9
Using 2 additional poles, repeat steps
5-8 twice more, continuing to use straps
that are located on the side of the mesh
that is facing upward.
11
10
12
5
Choose one pole and place across mesh
aligning it with straps as shown
.
(Straps are
indicated with white circles).
Top of upper pole
should meet edge of mesh with grommets.
Tie middle pole straps around poles in a knot.
With 3 poles tied in place, lift one end
of the mesh and carefully turn it over
so the remaining 3 sets of tie straps
are facing up.
Using the remaining 3 poles,
repeat steps 5-9.
Gather mesh and attached poles.
Blank Foam
Airzone
Embossed
Foam
Top
End
Bottom
End
