STEP 6
The interior Garnish Trim Ring must be trimmed
to fit your particular Caravan roof thickness. To
accomplish this, measure the distance from the
vehicle ceiling surface to each corner of the
MAXXFAN
Control Plate.
Most Caravan roofs have some slope, so
measuring each corner is necessary. The
Garnish ring should be cut 6mm to 12.5mm longer
than the dimensions measured at each corner.
In Picture #6 to the right, the installation measures
90mm from the ceiling (this is an example only) to
the Control Plate. After adding 12mm as in this
example, using a ruler, place a mark at 102mm
on each corner of each side of the Garnish Ring
(refer to 6A below). Once marked, draw a line
connecting all 102mm markers on the outside of
the Garnish ring and trim accordingly (refer to 6B
to the right).
STEP 7
Complete the installation by placing any excess
wiring to the inside of the roof opening and sliding
the Garnish Ring into position. Fasten in place by
using the four painted flat head screws provided.
NOTE:
DO NOT probe or tamper with the thermostat
sensor or IR sensor shown in illustration #6 above.
MEASUREMENTS STATED
IN STEP 6 ARE USED AS AN
EXAMPLE FOR ILLUSTRATION
PURPOSES ONLY
7
CONGRATULATIONS!!!
You have successfully completed the
installation of your new
MAXXFAN
.
If you have questions, please visit
www.Airxcel.com or contact your
AIRXCEL / MAXXAIR Distributor.
FOR REMOTE CONTROL MODELS:
Attach the included cradle to wall with (2) #6
screws provided. Handheld Remote Control may
be placed into wall cradle for storage.
6A
GARNISH RING
6B
GARNISH
RING
6
IR RECEIVER
90mm
CEILING
