5
Marvair MPC-10 PDS/Manual, 09/2020 New
1.
This button displays the current temperature, humidity, and mode of the controller. The controller can be
in auto (user sets up a range and the controller heats or cools depending on demand), Cooling (Controller
will only cool the space), Heating (Controller will only heat the space), and Off (Controller does not allow
for any cooling/heating). Once the button is pressed the cooling setpoint, heating setpoint, and T-Stat
Mode can be changed.
2.
This area displays the status of each unit. The controller can be set up for any number of units between
1 and 10 and will only display the units selected (E.g. If the user selects 5 units then only units 1-5 will
be visible). The status that can be displayed for each unit are as follows: Cooling, Heating, Blower, Fault,
Standby, Shutdown, and T-Stat Off.
HMI Main Screen (with Set Points Shown)
1.
Once the button on the main screen is pressed this section appears. From here the user can make changes
to the cooling/heating setpoint in 1° increments or change the mode of the controller. The controller has
a built-in offset of 5° for the cooling and heating setpoints (E.g. If the cooling setpoint is set to 72°F then
the heating setpoint cannot go above 67°F).
