ICE EX04-18 Heat I&O Manual 06/2020 Rev.1
12
4.2 Fan
If a fan fails, the fan can be replaced after dismounting the service panel. Using only
Industrial Climate Engineering spare parts to prevent any incompatibilities. Check the
weather seals after replacing the fan.
Service procedure:
1. Make sure all the power have been disconnected;
2. Dismantle the connector panel;
3. Dismantle the inner fan service panel;
4. Disconnect the connector of the fan; dismantle the fan with the frame;
5. Reverse the 2 and 3 steps to mount the new fan.
4.3 Controller
If the controller fails, ask for Industrial Climate Engineering’s standard spare parts, after
dismantling the service panel, the control board can be reached. Check the weather seals
after replacing the controller.
Service procedure:
1. Make sure all the power have been disconnected
2. Dismantle the inner fan
3. Disconnect the wiring of the controller
4. Dismantle the controller
5. Reverse the steps 2, 3,4 to mount the new controller
4.4 Heater (Optional)
If the heater fails, please contact Industrial Climate Engineering to order replacement
parts. Remove the installation of panels and fans; you can easily remove the fault heater.
Check the weather seals after replacing the heater.
In accordance with the following steps to replace the heater:
1. Be sure to close all of the circuit breakers
2. In accordance with instructions in section 4.2, remove the fan components
3. Remove heater wiring
4. Removal of the fixed heater screw
5. Follow the steps to the opposite of 2, 3, 4 steps to install a new heater and reinstall
the interior fan.
4.5 Heat Exchanger
If the heat exchanger is exposed to dirty ambient air, Use compressed air or clean water
to clean the heat exchanger, Note that before cleaning you must confirm that heater
power has been disconnected.
