Airwell 7SP023054, Руководство по обслуживанию

Страница: 37 / 69

TROUBLESHOOTING
HKD DCI 37 Version - 1
10.1 Indoor Unit Error Display
Operation
lamp
Timer lamp Display LED STATUS
☆
1 time X E0 Indoor unit EEPROM parameter error
☆
2 times X E1 Indoor / outdoor units communication error
☆
4 times X E3 Indoor fan speed has been out of control
☆
5 times X E4
Indoor room temperature sensor T1 open circuit or
short circuit
☆
6 times X E5
Evaporator coil temperature sensor T2 open circuit or
short circuit
☆
7 times
X EC Refrigerant leakage detection
☆
1 times O F0
Overload current protection
☆
2 times O F1
Outdoor ambient temperature sensor T4 open circuit or
short circuit
☆
3 times O F2
Condenser coil temperature sensor T3 open circuit or
short circuit
☆
4 times O F3
Compressor discharge temperature sensor T5 open
circuit or short circuit
☆
5 times O F4 Outdoor unit EEPROM parameter error
☆
6 times O F5 Outdoor fan speed has been out of control
☆
1 times
☆
P0 IPM malfunction or IGBT over-strong current protection
☆
2 times
☆
P1 Over voltage or over low voltage protection
☆
3 times
☆
P2
High temperature protection of IPM module or
compressor top
☆
5 times
☆
P4 Inverter compressor drive error
O
（
light
）
X
（
off
） ☆（
flash
）
* Fault Symptom: The display board shows a garbled code or a code that is not an error code found in
the service manual nor a temperature reading.
Trouble shooting:
Use the remote controller. If the unit does not respond to the remote, the indoor PCB needs to be
replaced; if the unit does respond, then the display board needs to be replaced.