15.
Empty the cold-water reservoir by pressing the cold-water tap
(blue trim).
16. Repeat steps 10, 11, 14 and 15 to rinse.
17. Clean small parts (faucets, floater, no-spill cone and drip tray) in
the upper rack of the dishwasher. The cold-water reservoir can be
manually cleaned with a cleaning solution and a clean towel.
18. Re-install the faucets, the floater, the no-spill cone with blue filter,
the drip tray, the black ring and the water bottle. Wait until the
reservoir is full (no more air bubbles in the bottle) and check to
make sure there are no leaks (see Section B, paragraph 3)
19. Plug the cooler to a power outlet.
Cleaning the cold-water r
eservoir when not cleaning the hot-water
tank (once every 3 months).
1. Unplug the cooler
.
2. Take the bottle off.
3. Drain the cold water by pressing the right hand faucet (blue trim).
4. Remove the no-spill cone. Then, remove the blue part (filter),
which must not be cleaned with the no-spill cone. The filter should
either be cleaned with a damp cloth or replaced;
5. Remove the drip tray located in front of the cooler.
6. Remove the floater inside the cold-water reservoir. Do not remove
the diffuser tube.
7. Remove the cold-water faucet (see page 7). Grip the cold water
(blue tab) faucet and turn it counter-clockwise until the nozzle is at
90° (horizontal to the right), then pull;
8. Clean the drip tray, faucet, the no-spill cone (w/o filter) and the
floater on the upper rack of a dishwasher.
9. Clean the cold-water reservoir with a cleaning solution and a clean
cloth.
After cleaning the cold-water reservoir, you need to re-assemble the
components:
10. Re-install the cold-water faucet (blue tab) (see page 8). It goes in
the right hand side socket (facing the cooler). Insert it in the sock-
et (fitting), with nozzle at 90°, push hard and turn clockwise;
FRANÇAIS
9.
Pour some water cooler cleaner (or
vinegar @ 20% concentration) into the
hot-water tube (long tube at the bot-
tom of the cold-water reservoir).
Some of the cleaning solution may
overflow into the cold-water reservoir,
it can be use to clean the cold tank.
10. Fill the cold-water reservoir with water, until it overflows into the
tube. This water is necessary to fill the hot-water tank as it will
flow from one tank to the other.
11. Bring the water into the hot-water reservoir by pressing onto the
hot-water tap (red) and stop as soon as water starts to come out
of the faucet.
12. Plug in the cooler and turn on the switch (rear of cooler) to heat
the hot water. Leave it on for 10 minutes.
13. Unplug the unit.
NORDIK
PACIFIK / BALTIK
14.
Empty the hot-water tank, using the hot water drain behind the
cooler.
FRANÇAIS
ENGLISH
ENGLISH
12
11
