4.
If you have a hot-water model (faucet with red trim), you must
bleed the air out of the hot water tank, before proceeding any
further. This is done quite easily as follows:
* Pull the child-safety lever located underneath the hot-water
tap and press down;
* Wait for the water to come out of this faucet;
* Stop when water flows out of the nozzle (this means that the
water from the bottle filled the hot water tank located under-
neath the cold- water reservoir;
* Turn-on the hot water switch located behind the cooler.
NORDIK
PACIFIK / BALTIK
FRANÇAIS
* 2 faucets:
o 1 for the cold water (blue trim)
o 1 for the hot water (red trim) or
room temperature water (white
trim)
* 1 floating baffle
(inside the cold water reservoir)
3. Choosing the right place to install the cooler:
* Install the water cooler in a well-ventilated place, where tem-
perature is between 0°C and 40°C (32°F and 120°F).
* Ensure sufficient air circulation by keeping a minimum clear-
ance of 5 cm (2 in) around the unit.
* Make sure to place the water cooler on a flat surface (maxi-
mum 5° slope).
ST
ART USING THE COOLER
1. Cooler should not be connected until you r
each step #7.
2. Your new cooler was cleaned prior to shipment but not sanitized,
so we still suggest that you sanitize it before using it. (see section
‘’Cleaning the cooler’’)
3. Clean the neck of the water bottle before installing it. Turn the bot-
tle upside down and install it into the no-spill cone, aligning the
cap with the rod of the no-spill cone. Some people do not use no-
spill devices, thus you just need to remove the cap on the bottle
and turn it over on top of the cooler.
FRANÇAIS
ENGLISH
ENGLISH
4
3
