23
T R
MT-4S 2.4GHZ FH4T RADIO SYSTEM USER'S GUIDE
The Servo Speed function allows you to slow the transit speed of the Steering, Throttle, Auxiliary 1 and Auxiliary 2 servos. Servo
transit speed can be slowed in both the Forward and the Return to Neutral directions independently. When driving your model,
proper steering and throttle control are vital. For example, lowering the transit speed of the steering servo can help to limit
excessive steering, which will enable you to achieve smoother cornering. In addition, lowering the throttle servo speed can help
to ensure smooth throttle control.
Controlling the Curve Function:
1) By assigning the Steering, Throttle High and Throttle Brake Rate and Point programming functions to one or more of the
Trim Switches, Auxiliary Lever or Dial Knob, these functions can be adjusted while driving without accessing the Programming
Menu. In addition, the Steering Curve and Throttle Curve functions can be Toggled OFF and ON by assigning them to one
or more Push-Button Switches. For more information, see the Key Assignments section on pages 53 through 58.
Auxiliary 1 and Auxiliary 2 Rate and Point programming functions cannot be assigned.
Neutral
Right End Point
Left End Point
Neutral
High Side End Point
Steering, Auxiliary 1 and Auxiliary 2
Throttle
Throttle Servo Speed affects only the Throttle High Side. The Throttle Brake Side is unaffected.
PROGRAM
1) From within the CURVE menu, scroll DOWN to highlight POINT 50%. Press the ENTER
key, then scroll UP or DOWN to increase or decrease the Point percentage value.
Increasing the Point percentage value will shift the Neutral Point to one side of center
and decreasing the Point percentage value will shift the Neutral Point to the opposite
side of center.
CURVE POINT setting range is 5% to 95%. The default setting is 50% (Centered).
04.cURvE (ExpOnEnTIAl AnD ARc)
pROGRAM
05.SpEED (SERvO SpEED)
pROGRAM
3) Scroll UP or DOWN to highlight the desired channel you would like to change
the Forward Speed value for. Choose from either [ST]:FORWARD 0 (Steering),
[TH]:FORWARD 0 (Throttle), [A1]:FORWARD 0 (Auxiliary 1) or [A2]:FORWARD 0 (Auxiliary 2).
Adjusting the Forward Speed Value:
1) From the Top Screen, press the ENTER key to open the Programming Menu list.
2) Scroll UP or DOWN to highlight the SPEED menu, then press the ENTER key. The SPEED
menu will be displayed and [ST]:FORWARD 0 will be highlighted.
4) Press the ENTER key, then scroll DOWN to decrease servo Speed in the Forward
direction. Decreasing the Forward Speed value will cause the servo transit time to slow
down when it moves from the Neutral position to either End Point.
SPEED FORWARD setting range is -100 to 0. The default setting is 0 (Normal Speed).
