SS
‐
300
‐
AT
‐
C
‐
60
Installation
Guide
17
Chapter
6
SS
‐
300
‐
AT
‐
C
‐
60
Config
Shell
Commands
The
following
tables
detail
the
SS
‐
300
‐
AT
‐
C
‐
60
config
shell
commands.
Table
1.
get
commands
get Commands
Command Description
get ap
Displays all the currently visible APs
get interface
Displays Network Interface speed and mode
get ip config
(deprecated)
Displays the IP information
get log
Displays the log information as it is created
get log config
Displays the configuration of the logger
get mode
Displays the mode in which the Sensor is currently configured
get rf
Displays if RF monitoring for a Sensor is ‘ON’ or ‘OFF’
get serial num
Displays the Board Number
get server discovery
Displays the Server discovery/setting information
get status
Displays the current running status of all the components
get version
Displays the version and build information of all the components
get vlan config
Displays listing of VLANs which are configured for monitoring by ND or Sensor
get vlan id
Displays listing of all VLANs which can be detected by ND or Sensor
get vlan status
Displays status of VLANs which are configured for monitoring by ND or Sensor
get model
Displays the Sensor Model
get antenna
Displays antenna configuration (Internal/ External)
Table
2.
set
commands
set Commands
Command Description
set erase
Sets the erase character to ^H.
set interface
Sets Network Interface properties like auto negotiation, speed, and duplex settings.
set ip config
Runs through the current VLAN and IP config wizard.
set server discovery
Sets the Server discovery information.