New Master 35 Petrol/Gasoline Impact Wrench
WARNING
Always stop Impact Wrench and disconnect Spark Plug before carrying out any of
the following procedures unless they require operation.
If these solutions do not solve the problem please contact your approved Service
Centre.
PROBLEM
POSSIBLE CAUSE
SOLUTION
Engine will not start or will run for only a few
seconds after starting (please check ignition
switch is in START position 1)
1. No spark
2. Flooded Engine
1. Watch for spark at spark plug tip. If
there is no spark, repeat test with a
new spark plug (RCJ-4)
2. Check Stop Switch and stop wire.
3. Check Coil for correct operation.
2. Set the On/Off Switch to STOP.
Release the Cover Clips and remove
Spark Plug and open throttle fully.
Pull Starter rope several times to
clear the Combustion chamber. Refit
Spark Plug and Plug Cover firmly. Set
the On/off Switch to Run and re-start
engine.
Engine starts but will not accelerate properly or
will not run properly at high speed
Carburettor requires
adjustment
Contact your Service Dealer
Engine does not reach full speed and/or emits
excessive smoke
1. Check oil fuel mixture
2. Air Filter dirty
3. Carburettor requires
adjustment
1. Use fresh fuel and the correct 2 cycle
oil mix.
2. Clean per instruction in Maintenance
– Air Filter Section.
3. Contact Service Dealer
Engine starts, runs and accelerates but will not
idle
Carburettor requires
adjustment
Turn Idle speed screw “T” clockwise to
increase Idle Speed. See Operation
–
Carburettor Adjustment.
1. Toolkit Part No. 1140.1011
– Only supplied complete
Allen Key
4mm
Allen Key
5mm
Allen Key
6mm
Spanner
10-13mm
Spark Plug Combination
Spanner
8mm Tube Spanner
Spanner 22mm }
Screwdriver }
Torx Spanner T27
Fuel Funnel
2. Storage
a)
Empty and clean the Fuel Tank and Gearbox.
b)
Dispose of fuel and oil safely in accordance with local regulations.
c)
Start the engine to use up any fuel left in the Carb and avoid damage to the Diaphragm.
d)
Store the Wrench in a dry area.
e)
Keep off the floor and away from sources of heat.
3. Scrapping the Wrench
a)
Most of the parts can be recycled.
Please check local regulations
b)
Avoid pollution of soil, air and water.
c)
Please destroy the CE machine label and Manual.
GENERAL INFORMATION
TROUBLESHOOTING ADVICE
18
