Air4Gp Installation Guide
Page 27
Commercial in Confidence
UGD-D00236 Rev B
4 Install Air4Gp
Install the Air4Gp base station by pole mount or wall mount.
Caution:
Proper local rigging and hoisting practices should be followed when
installing the Air4Gp. The pre-assembled handles are
not
to be used for
hanging, attaching or hoisting the unit into place.
4.1 Pole mount configuration
The following image shows the pole mount assembly.
Figure 8 – Pole Mounted Air4Gp Assembly
To mount the Air4Gp on the pole mount configuration, perform the following steps:
1. Assemble the 4 threaded bolts (M8 x 200) onto the Tilting panel and hand-tighten M8
nuts onto the threaded bolts (on the outer side).
2. Assemble the 2 interface brackets (left and right) with their threaded pin facing outwards
(in the up position) to the threaded holes on the Air4Gp back.
3. Attach the GPS on to the GPS antenna bracket and attach to the top of the Air4Gp.
4. Assemble the two (2) Back brackets onto the Tilting panel to properly fit on the pole.
5. Align and position each of the 2 back brackets at the proper height to attach the Air4Gp
(with the Tilting panels pivot grooves facing up). Adjust the upper bracket and tighten in
place. Adjust the lower bracket and hand-tighten.
